HD-300 and Harmony 1100 RF

[benjatelcom]

Greetings to all,

I have been struggling to get the Harmony 1100 universal remote to properly control the HD-300 via it's RF extender.

I used to use the IR extender on the HD-300 but it quit working.

So far I have used existing codes out on the Internet, my own analyzed codes, RAW codes, and now codes that have been "trimmed" by Harmony support.

There is significant lag from button push to RF/IR command output.
The inter-key delay is high and I can't adjust it lower.
The Harmony support generated codes don't permit repeating commands by holding down buttons.
The remote queues up button presses and will continue to issue them forever (had my volume run-away high once because of this).

Is anyone using HD-300 with a Harmony 1100? Would you be willing to chat about your config?

I'm at wits end with it, about to buy a $100 wired IR extender for the system.

[gplasky]

I'm using the Harmony 900 with the RF/IR extender on a HD300 in the living room and on a HD200 in the bedroom. Did nothing special and I believed I used the HD200 code from the Harmony site. I can confirm tonight. (I initially had a Harmony 1000 in the living room. Again-did nothing special.)

Gerry