HD200 reboot

[phunny]

My HD200 recently turned into a brick. I rebooted it by holding down the back key etc. It came up out of the dead and worked fine for a few hours. I went to unplug it so I could get to the system menu to see if there are any updates. When I plugged it back in though it was a brick again, just displaying the sage tv logo. Is there away to get from a menu screen to the setup without powering the hd200 down? Thanks

Andy

[JetreL]

You may want to try the recovery process listed here: LINK [forums.sagetv.com]

I would try a new power brick first to remove that out of the equation.

Best of luck!

[cheekymonkey]

I see you already tried the debrick proceedure, I suggest you contact support as mine started playing up in March with various lockups then progressed to your state b4 only running for about 30min after de-bricking. It has now been sent back

Other people are starting to get the same issue, see here