|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-22-2007, 12:05 AM
|
|||
|
|||
|
Is it possible to convert from client mode to service mode while retaining recording history? I tried this several months back and was unsuccessfull. I made a backup of my Sage folder, deleted the program directory, re-installed Sage in service mode and copied wiz.bin back. This did not work as wiz.bin was overwritten. Is my sequence correct? I'd like to have the ability to kill the client without stopping recording.
Thanks in advance for your replies. --Joel 
|
|
#2
12-22-2007, 12:14 AM
|
||||
|
||||
|
You don't need to uninstall/re-install to change from or to service mode. Just configure the service option -- see the Starting SageTV & subsequent sections in chapter 2 of the PDF manual, found in your SageTV dir. That starts on p. 14 for the v6.3 manual.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
12-22-2007, 01:47 AM
|
||||
|
||||
|
Although be aware that if running vista with UAC enabled, the service tries to read wiz.bin and sage.properties from a different directory than when running in non-service mode.... (See FAQ)
(I have given up on UAC on my vista install...)
__________________
Check out my enhancements for Sage in the Sage Customisations and Sageplugins Wiki 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hauppauge IR Blaster won't work in SageTV Service Mode | Retardical_Sam | Hardware Support | 21 | 04-26-2010 08:43 AM |
| Using Sage Service mode with a NAS | sunray | Hardware Support | 5 | 03-23-2007 11:00 AM |
| Service mode help needed please | kkeller20 | SageTV Software | 2 | 01-20-2006 02:43 PM |
| Client fails to find server, 4.1 or service mode problem? | Todd33 | SageTV Software | 2 | 12-23-2005 09:38 AM |
| sage client fails with server in service mode | folly12345 | SageTV Software | 2 | 05-22-2005 05:04 PM |
Linear Mode
