|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-22-2005, 11:37 PM
|
|||
|
|||
|
Client fails to find server, 4.1 or service mode problem?
I can't seem to connect despite the IP and networking not changing. Since tried it last I upgraded to 4 and changed to service mode, should either of these give me issues?
Any way to problem shoot the client connection? 
|
|
#2
12-22-2005, 11:46 PM
|
||||
|
||||
|
Both the client & server have to be v4.1, but if you have a firewall, make sure the service is allowed through. If you previously gave permission for SageTV & the client, now you'll need to do so for the service. Double check the client's firewall too, since the firewall may notice the client is not the same version that was given permission previously.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
