|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-18-2007, 07:59 PM
|
||||
|
||||
|
Exit Change with Remote Key
I'm almost certain I've seen this somewhere, but I can't find it. I want to be able to have a single remote button mapped to exit Sage not sleep it. I have HIP installed to start Sage from scratch when it's not running and I need to be able to do the opposite. I can't figure out how to do it in HIP.
Never mind, I got it working with EventGhost. EG makes much more sense to me than HIP does. Last edited by toricred; 11-18-2007 at 10:06 PM. Reason: Solution Found 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about ac3filter and the Hauppauge remote | jbarr | Hardware Support | 9 | 01-17-2008 04:39 PM |
| Harmony 520 Remote With Hauppauge Commands | Taddeusz | Hardware Support | 5 | 04-27-2007 06:04 AM |
| MCE Remote not work fully with Placeshifter | devinteske | SageTV Placeshifter | 5 | 02-08-2007 11:45 PM |
| Hauppauge remote - same key, different results | Ken C | Hardware Support | 3 | 12-13-2005 10:29 PM |
| How to change channels with Hauppauge remote | Terrapin | Hardware Support | 10 | 10-05-2005 02:25 PM |
Linear Mode
