|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-13-2011, 04:39 PM
|
|||
|
|||
|
Cable Station was remapped--cannot get HDHR to work
this may have been covered in the past, but my forum searches were fruitless. Help is very much appreciated.....
My cable company remapped my local CBS affiliate to a different frequency. I am trying to get the HDHR to recognize the new mapping, but it doesn't work in Sage. What I did was rescan in the HDHR set up program, make sure the right channels were enabled and then saved the file. I can view all the channels within the HDHR set up program--including the local CBS channel that was moved. Everything works perfectly in the HDHR set up program. In Sage, I removed the tuner, added it back, then rescanned. Everything works but for the CBS channel that was moved. When I try to preview CBS, it shows a 99-100% signal strength, but just a blank screen. it must be something simple, but for the life of me I can't figure out what is going wrong. Any help is appreciated. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HDHR: Can it tune analog cable? | electron | Hardware Support | 5 | 10-29-2010 01:07 PM |
| help - HDHR 2nd tuner dish not cable | LaoChe | SageTV EPG Service | 0 | 12-29-2008 04:54 PM |
| Bad day for my Cable, and now the HDHR is not working | m1abrams | Hardware Support | 2 | 05-15-2008 10:35 AM |
| Changing cable station | nathanm | Hardware Support | 28 | 12-25-2006 07:01 AM |
| Remapped HD channel don't work??? | jbuszkie | SageTV Software | 5 | 05-25-2006 09:27 PM |
Linear Mode
