|
|
|||||||
| SageTV EPG Service Discussion related to the SageTV EPG Service used within SageTV. Questions about service area coverage, channel lineups, EPG listings, XMLTV, or anything else related to the service or programming guide data for SageTV should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-19-2009, 11:55 AM
|
||||
|
||||
|
EPG - adding removing channels?
Ok, I recently started over with sage, and reloaded everything from scratch - I had an incompatability issue. Now I cannot add/emove channels? When setting up the source they look correct but the actual giude does not represent the setup??
I have gone through the FAQ and tried what's in there. After removing video sources, if there is any referances to EPG or CAp card shouls I delete them? Not sure where to go from here. PVR-150, HVR-1600 - using DirectTv Aver 780M for a few cable channels. I run SageMC normaly, but for this issue I am only running the default interface. Thanks, Skybolt 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adding Favorites not in the EPG | sharker | SageTV Software | 4 | 09-09-2009 06:57 AM |
| Manually removing unwanted channels - .frq files - advice needed. | sfag | SageTV EPG Service | 8 | 01-27-2009 11:03 AM |
| adding channels to EPG? (analog/HD ota & hd cable) | rnewman | SageTV EPG Service | 5 | 03-09-2007 05:38 PM |
| How to refresh EPG after adding a channel? | stevech | SageTV EPG Service | 3 | 01-02-2006 09:55 AM |
| adding channels | peter | SageTV Software | 1 | 07-09-2003 06:27 PM |
Linear Mode
