Only One Tuner Showing Up

BobbyDing · #1 08-27-2009, 04:00 PM

Hi All,
I'm hoping you can toss some hints my way to get this functioning. I have been using my PVR (latest SageTV on XP SP2) with an Avermedia MCE PCI 180 installed for a few weeks now, and all is working. Today I rec'd and installed a second Avermedia MCE 180. XP saw the new card and installed it. I know show two 180's under the device manager, with no conflicts (both say enabled). However, when I run SageTV Setup, it still only shows one capture device...I tried adding another 180 (as it is the only selection), but after scanning for channels, it still comes back to just one card showing under setup That being one Avermedia 180 card. I tried removing the old card leaving just the new card installed, and it worked. So both cards are functioning. Any hints on how to get Sage to see the new card? Or does two of the same device show only as one?

Thanks!

Bobby

BobbyDing · #2 08-28-2009, 08:30 AM

Today (day after) I tried again, and the second card appeared.

Not sure what the difference was. Thanks anyway!!

Bobby

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Lost 2nd Tuner on terratec cinergy dual tuner	michaeldjcox	Hardware Support	2	07-10-2007 01:57 AM
Dual Tuner DVBT showing 2 of each channel in EPG	maninblack_30	SageTV Beta Test Software	4	10-18-2006 04:57 AM
HDTV Built-In tuner (Samsung 50" DLP) VS. Vbox 150 Tuner in PC?	Generalg	Hardware Support	3	07-17-2006 10:59 PM
two 150s, only one tuner showing up??	orangezero	Hardware Support	4	01-14-2006 11:34 AM
Going to add USB2 tuner to multi tuner setup.	ToxMox	Hardware Support	9	03-05-2004 10:41 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)