|
SageTV EPG Service Discussion related to the SageTV EPG Service used within SageTV. Questions about service area coverage, channel lineups, EPG listings, XMLTV, or anything else related to the service or programming guide data for SageTV should be posted here. |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
||||
|
||||
Which remap options to use?
The two channels in question:
12 - SDTV Cable 54-1 HDTV OTA They are both the same channel, but unfortionately Zap2It does not carry the complete EPG data via SageTV for the OTA channel. It is correct on the web, just not in SageTV. I would like to keep both channels in the guide, just clone the EPG data for channel 12 onto channel 54-1. I tried the "map different station to this physical channel". Now the EPG correctly shows 54-1 data, but channel 12 disappeared from the EPG. With of the other options would work better? This is not very well explained in the manual. Would be nice to see some pictures of the changes (hint hint). thanks, dave |
#2
|
||||
|
||||
If you remap the station, both channels will be the same station & thus will be merged in the guide. If one is HD and one is SD, then you will run into airings being marked as HD when they are not, or vice versa.
If the OTA channel isn't listed in your lineup, then I think your only options are to let it use the listings from its broadcast stream, map it to some other station like you did, or try adding the channel using the station ID number from the Zap2it site. Adding the channel using the Zap2it ID will only result in getting EPG data if SageTV happens to have access to the station's listings even though it isn't part of the lineup it shows to you; i.e.: if it isn't an OTA-only station as far as Zap2it's listings are concerned. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. |
#3
|
||||
|
||||
Both channels are listed in the EPG, its just that the OTA one has only partial EPG data. I just want the EPG data from channel 12 copied to channel 54-1.
dave |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Possible to remove aspect ratio options? | m1abrams | SageTV Media Extender | 8 | 01-19-2011 03:32 PM |
How to get the folder options dialog back? | Ansy_74 | SageTV Software | 4 | 04-25-2010 06:20 AM |
Troubles with MCE remote key remap and music playback | CatsLab | SageTV Software | 3 | 11-28-2008 10:51 PM |
SageMC 6.3.8 | dflachbart | SageMC Custom Interface | 231 | 11-18-2008 12:12 PM |
SageMC settings menu suggestions | tchapin | SageMC Custom Interface | 2 | 11-17-2008 01:03 PM |