|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-27-2005, 12:20 AM
|
|||
|
|||
usb-uirt stops working during setup
When I go to the setup wizard and it gets to the part where you enter "0" on the remote the usb-uirt quits working, i can tell because the light stops blinking when i hit the buttons on the remote, then it gets an error after it sits for a minute and then tells me to hit enter to try again. this is frustrating because it DOES work when i map remote buttons to sagetv functions. will the madness ever end!
Last edited by jsantoy; 01-27-2005 at 12:22 AM. 
|
|
#2
01-27-2005, 12:31 AM
|
||||
|
||||
|
Does this thread cover it? -- Yet another USB-UIRT learning problem thread... (See post 3 about not using service mode temporarily.)
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
