|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-16-2004, 10:53 AM
|
|||
|
|||
|
Sage and DirectTV
I have SageTV, SageClient and SageRecorder working but I have a small problem and hoping someone has delt with it.
I have a Sony A50 reciever that accepts local channels on 4,5,7 but I also have a B3 that takes locals on 961,962,963. Is there a way to get things mapped so that I can watch locals. Currently if I watch something on ch 5 but it hits my B3 reciever it wont' work. Any of this make sense? 
|
|
#2
10-17-2004, 12:22 PM
|
||||
|
||||
|
Go to your channel set up and see if both the low number local channels (4,5,7) and the high numbered ones (900s) are enabled (green ball).
If you would normally watch your local channels with the STB by selecting the low channels, then disable the 900s. IF you use the 900s then disable the 4,5,7 channels in the set up.
|
|
#4
10-17-2004, 07:58 PM
|
|||
|
|||
|
In the channel setup you can map the high or low ones to a new channel number. I messed with it before without much success but I was doing it for a different reason. Maybe you can just remap one set so they would all be the same.
Randy
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
