Adding HDHR ATSC Tuner to Sage??

[Ron]

My legacy HDHR tuner bit the dust so I replaced it with an HDHR3 ATSC tuner. The Silicon Dust HDHR utility seems to access the tuner just fine, but I haven't figured out how to add it to Sage. Of course, all those instructions are no longer on the Silicon Dust website, and my searches of the Sage forum hasn't revealed anything to help.

Can someone please direct me to where I can find the instructions to add my replacement tuner?

Thanks...

[Fuzzy]

Originally Posted by Ron

My legacy HDHR tuner bit the dust so I replaced it with an HDHR3 ATSC tuner. The Silicon Dust HDHR utility seems to access the tuner just fine, but I haven't figured out how to add it to Sage. Of course, all those instructions are no longer on the Silicon Dust website, and my searches of the Sage forum hasn't revealed anything to help.

Can someone please direct me to where I can find the instructions to add my replacement tuner?

Thanks...

The 3 should set up exactly the same way the 1 did. You have to run the HDHR config utility and set it for SageTV, then simply add it as a source in sage (it should show up). Then set it's EPG source, and do a scan.

[Ron]

Thanks!!

I was using my Mac and the setup utility wasn't just never showed up. I then went to my PC (Sage server) and downloaded the latest Silicon Dust software and the setup utility was there, i ran it, and all is good. It's been so long since I had to do this that I completely forget the procedure. Sage now sees the new tuners and I'm in business again.

Anyway, again thanks Fuzzy.