WMDRM Pairing Red on Ceton PCI-e Card

heffneil · #1 08-10-2013, 07:52 PM

I was hoping some people could give me some help here. I have a PCI-e Ceton card and it stopped working once I replaced my motherboard. I think I have it communicating properly because I can get to it at 192.168.200.1 when I go there and tune to a channel it will show me "one copy" or "copy freely" so it is tuning but in WMDRM I get "Pairing Red". Also I am using sagedct (of course) and it tunes the cable card but it shows no signal. I tried the debugging tools a bit and when I tune the file doesn't seem to grow. Any ideas?

Thanks,

Neil

mguebert · #2 08-11-2013, 07:49 AM

You will need to go into Windows Media Center and setup the cablecard tuner again. This action will reset the WDRM pairing and allow you access to the copy freely content again.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Any issues using Ceton PCI Quad-tuner Card with Sagetv	rdefino	Hardware Support	5	08-09-2013 12:37 AM
youtube pairing?	bjkiller	SageTV v7 Customizations	1	08-05-2013 02:58 AM
Ceton $200?	KryptoNyte	The SageTV Community	3	02-20-2012 08:15 PM
cable card, ceton, firewire, etc.	The Truth	Hardware Support	23	01-29-2012 07:41 PM
Ceton Cable Card Tuner	bcjenkins	SageTV Linux	2	08-01-2011 07:11 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)