|
Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
usb-uirt extra digit
I'm hoping this is a simple thing but I'm getting frustrated trying to find documentation for usb-uirt and it's configuration with sage.
First error is all me, I bought a usb-uirt before I did my homework and I didn't buy the 56kHz receiver. Of course, my set top box is a scientific atlanta 3200 and I was swinging in the wind until Wheemer graciously gave me his old .ir file. Now I can change channel and as far as I can tell, all the digits work. It might be the "ok" that's bad but there always seems to be an extra "1" at the end. I'm a bit tired of watching the cable provider fluff channel... Is there a way to control what gets sent through the usb-uirt ? The set-top box works with only the 3 digits. Gog |
#2
|
|||
|
|||
found it in the source config, "channel change confirm code" was set to 1...
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
usb-uirt blaster misses first digit ocassionally | bmh | Hardware Support | 16 | 11-22-2008 11:09 PM |
USB UIRT is sending double digit of the number | mistergq | Hardware Support | 4 | 08-29-2008 08:04 PM |
Remote tuning problem - USB UIRT drops first digit of 3-digit channels | swad | Hardware Support | 1 | 10-07-2005 12:37 PM |
USB-UIRT missing first digit | sting7777 | Hardware Support | 17 | 08-01-2005 09:00 AM |
Learning extra IR codes with the USB-UIRT | PeteInSF | SageTV Beta Test Software | 1 | 04-24-2004 08:33 PM |