|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-20-2008, 11:24 PM
|
|||
|
|||
|
Restoring a Remote Control Setup
I am using a USB-UIRT IR receiver/Blaster and need to know how to restore the key setup for my remote control after an Un-install/Re-Install. I can't find a file that is changed when I make changes to the remote setup. I have saved the full sagetv directory so I hope it is just a matter of finding the correct file.
The Un-install/Re-Install is the only fix I have found so far for the transfer from my HDHomeRun stopping after 30 seconds or so and freezing the picture. 
|
|
#2
12-21-2008, 01:16 PM
|
||||
|
||||
|
Are you talking about the blaster portion to control an STB or just the remote to control the SageTV interface?
The IR codes assigned to each command for the UI are stored in the properties file on the ui/rc_mappings/<command name> lines. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Tags |
| reinstall, remote control, restore setup |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Remote control - change IR frequency?? | glennsantacruz | SageTV Media Extender | 1 | 12-18-2008 09:40 AM |
| Dropped favorite recording -- with debug logs | Surtr | SageTV Software | 4 | 02-19-2008 10:48 AM |
| JP1 Universal Remote Control (URC-1067) for Hauppauge MVP | krasev | Hardware Support | 0 | 12-22-2007 12:02 PM |
| Using a universal remote control | mmac911 | Hardware Support | 2 | 12-13-2006 07:21 AM |
| Remote Control To Use (Harmony setup help?) | TheraEdge | Hardware Support | 66 | 04-20-2006 06:21 PM |
Linear Mode
