Watching from two outputs?

[ry12a]

Hi
I would like to watch the output from my PVR350 on the TV and the output from my graphics card on my projector at the same time.
Is this possible with Sage (either version)?
Thanks!

[mlar]

Your question is not clear. Do you mean displaying the desktop on the projector at the same time as you display Sage TV on the TV? Or display SageTV on both? In either case, yes you can, but remember that if you try to watch video on both at the same time, they will be out-of-sync, since the PVR-350 and software decoder will not be in sync, and this will also have an effect on the audio.

[ry12a]

Apologies for not making my question clear
I want to be able to watch the sage output from both the the PVR350 and the RGB card output at the same time....in two different rooms.... so the delay offset is not an issue...I presume I can use the 350 outputs(both audio and video) to the TV and then use the RGB and soundcard outputs to the projector setup?
What steps do I have to take to configure this? I have my desktop set to match the resolution of the projector. would that have an impact on the settings I need for the TV?
So many questions!
Thanks for any light you may be able to shed on this!
Also will this only work with v2 or is it possible with 1.4 as well?

Thanks!

[fidget]

Originally posted by ry12a
Apologies for not making my question clear
I want to be able to watch the sage output from both the the PVR350 and the RGB card output at the same time....in two different rooms.... so the delay offset is not an issue...I presume I can use the 350 outputs(both audio and video) to the TV and then use the RGB and soundcard outputs to the projector setup?
What steps do I have to take to configure this? I have my desktop set to match the resolution of the projector. would that have an impact on the settings I need for the TV?
So many questions!
Thanks for any light you may be able to shed on this!
Also will this only work with v2 or is it possible with 1.4 as well?

Thanks!

Changes made to 2. 0 will not yield the results that you want. SageTV now locks the monitor window to 720x480 to match the output of the 350. I believe this was done to speed up the rendering of the OSD. Even if your monitor is set to 720x480, you can't go full screen (this may be a bug).