|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-20-2007, 04:45 AM
|
||||
|
||||
|
VistaView Saber 2020 help
I installed it last night, used the lastest drivers from their site and the firmware update. Appeared to install correctly, was able to set it up in Sage 6.1.9, but neither channel would tune - got "no signal" - using RF hook up for the local Comcast cable. I know that cable has signal cause I had it hooked up to the tv's RF input.
So I updated SageTV to 6.2.10, but still no signal. Any thoughts? Otherwise it's coming out and my PVR500 is going back in. Thanks, Mike 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VistaView Saber 2020 question | davin | Hardware Support | 3 | 08-15-2007 09:12 AM |
| VistaView Saber 2020 | bjterry62 | Hardware Support | 82 | 07-18-2007 10:57 AM |
| VistaView Saber 2020 and Recording Qualities | pughrs | SageTV Beta Test Software | 7 | 01-20-2007 08:15 PM |
| Nvidia DualTV PLUS Vistaview Saber 2020 combo | deezldub | Hardware Support | 0 | 12-03-2006 06:46 PM |
| Saber 2020 : Use analog cable / STB on one card? | dmiraclejr | Hardware Support | 4 | 11-03-2006 08:08 AM |
Linear Mode
