|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-14-2006, 10:02 AM
|
|||
|
|||
|
5.0.4 Tuner problem
I just upgraded to 5.0.4 (from 5.0.2) and I'm now having problems with recordings. I am getting the wrong channel recorded. When I try to view that channel (4) it shows the wrong channel (8 - which was the same one recorded). If I up/down shift the channel, the correct (5 or 3) channel shows. I then up/down shift back to 4 and it shows properly.
This was working fine in 5.0.2. I have made no hardware changes to my system. I do have 2xPVR150 installed (not a change). The "Always tune channel" option is set to YES (not a change). Any thoughts on what I need to change? 
|
|
#3
06-14-2006, 10:04 PM
|
|||
|
|||
|
I have seen this twice since upgrading to 5.04, I can watch as Sage changes the channel on the recording. It has recorded the last few fine.
__________________
AMD Athlon 3000 |1GB Memory | eVGA 7600GS | 80GB, 300GB and 500GB SATAII | HDHomerun |Hauppage PVR-150 | SageMC 16x9 | Windows XP Pro.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
