Any way to view channel remaps?

[ripple]

At one point I remapped a few channels in my lineup but I'm not sure exactly which ones they were. Is there any way to see what remapping entries have been done? I know you can click on the Remap button to see if a particular channel is remapped, but it doesn't seem reasonable to check every channel in the lineup...

As an alternative, is there any way to "reset" a lineup back to it original state (i.e. remove all mappings)?

Thanks,
Kevin

[nielm]

Channel Mappings are stored in the Sage.properties file...

epg/channel_lineups/<some_number>=<channelID>,<channelnum>;<channelID>,<channelnum>;<channelID>,<channelnum>
etc

If you remove this line while Sage is shut down, the remappings should be reset.

[ripple]

Originally Posted by nielm

Channel Mappings are stored in the Sage.properties file...

Excellent! I was hoping Sage stored it there, but I didn't see any reference to it in the properties section of the manual.

Thanks!

[surge]

Originally Posted by nielm

Channel Mappings are stored in the Sage.properties file...

epg/channel_lineups/<some_number>=<channelID>,<channelnum>;<channelID>,<channelnum>;<channelID>,<channelnum>
etc

If you remove this line while Sage is shut down, the remappings should be reset.

I was about to post a question about channel mappings and found this thread.
It's exactly what I was looking for

How does this entry translate to the frq informaiton in the frq file.
My file is Hauppauge WinTV 418 TS Capture-0-QAM.frq

for example, how does
CH:35 major:0 minor:12 prog:212 phy:80 frq:559250000 mod:11 inv:0 #: DTV80.12

appear in the epg/channel_lineups/ section

thanks.