|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-07-2005, 02:54 AM
|
||||
|
||||
|
Installing a new harddrive
I recently bought a new 250GB harddrive and I want Sage to start saving the recordings to that primarily. I also want Sage to use the existing harddrive for storage space, in case the new one runs ouut, but mainly i want the new harddrive to get the new recordings. Is there any way I can prioritize the hard drives in Sage? The one thing I thought about doign was keeping the maximum size of the existing hard drive small but then I realized that Sage would probably delete my recordings. Any suggestions what to do?
|
|
#3
02-07-2005, 10:43 AM
|
||||
|
||||
|
... I'll just add that as long as you let enough recordings build up, your new drive will eventually get full enough where your old drive will be used also. This is covered in Appendix C of the SageTV manual, btw.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
