|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-04-2005, 12:20 PM
|
|||
|
|||
|
setting the tv out
Now I consider myself computer literate. Well at least I hope so.. I am a level II support specialist...but for the life of me I can't seem to get this software to play out to my television.
I have a WinTV 350 and GBPVR and the WinTV software plays fine. I am sure it is a setting that I am just missing and usually by the time I get off work from looking at a screen all day my eyes are burning and the last thing I want to search for is the setting. But I can't find it. I went through the setup a couple of times and same thing. I see input but not a place to set the output. Let me also say this is my first question of many down the road of owning my own PVR. Thanks in advance for all your help. (I hear the support on this forum is great) Rex 
|
|
#2
02-04-2005, 01:45 PM
|
||||
|
||||
|
Are you trying to use the 350 or your video card for TV-out? If you want to use the 350 for that, there are options in Detailed Setup -> Multimedia (p. 132 in the v2.1 manual in your SageTV dir) to enable using the 350.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
02-04-2005, 02:43 PM
|
|||
|
|||
|
right you are
thanks for the help... I must have been cross eyed to not have seen this option. I will print them manual out today and do a bit more reading to avoid el stupid questions.
rex
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
