|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-27-2005, 12:13 AM
|
||||
|
||||
|
SageTV Client question (another)
So I'm using SageTV client and am impressed. One question though: with the full version do you have to enter the server address every time you start it like you do with the trial version?
|
|
#2
01-27-2005, 12:18 AM
|
||||
|
||||
|
You can set it to auto-connect in Detailed Setup -> General. It is shown near the beginning of the manual, when it talks about connecting the client to the server: p. 17 in the v2.1 manual.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
