newbie question... PVR-150 blaster setup

[irousso]

Hi,
I am sorry if this question has been asked before - I was not able to find it...

I am trying to setup my IR transmiter than came with the PVR-150. The problem is that during the setup sages in Sage - I never get to the point which let me teach Sage the codes for my Sat box.
What I do is the following:
1. I choose my card port (composite/S-Video or tuner) - I select the composite
2. It asks me if I want to control external box - I click yes.
3. I choose the correct transmiter (PVR-150 in my case).
4. I am asked to choose the service - which I then choose cable/Sat.
5. I choose the '00000' zip code - as I am using the XMLTV plugin.
6. I then only see the XMLTV plugin - which I choose.
7. I see the channels lineup which were grabbed using the plugin.
8. That's it... I remap enable disable - but then I am done - and never got to the point where I can teach sage the codes.
Reading the manual this was supposed to be done by clicking new box - but using the plugin - I never get to that point.

Any help would be greatly appreciated!
Itay

[Opus4]

In the v2.1 manual, check the bottom of p. 197 for info about using the 150's blaster. You have to set up the blaster using the Hauppauge configuration program first. (The appendix was updated, but I suppose this means that step 5 of the setup wizard should be updated to reflect this too.)

- Andy

[irousso]

Thanks Andy.
From reading this section in the manual - then looking at the manual of the card, I don't think there is an option to teach the balster... only use the pre-configured box support it has...
Itay