|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-17-2005, 05:23 PM
|
|||
|
|||
|
Lag on Remote Commands
I've been running SageTv for about 6 months now. I keep the box pretty clean of extraneous processes and such, and it's been running fine. I just added an additional 250 GB hard drive (7200 rpm). Now I often get huge lags whenever I use the remote to execute a command. For example, it takes 6-10 seconds for a FF/RW command to execute, and almost a minute for a 'Stop' command. Any ideas? Thanks.
Specs: P4 1.4 Ghz 256 RAM 40 GB, 160 GB, 250 GB Hard Drives. 3 Hauppauge PVR-250s Radeon 9600 Pro - S-Video to TV 
|
|
#2
01-17-2005, 05:43 PM
|
||||
|
||||
|
One thing causing something like that in the past was when Norton AntiVirus was scanning the videos as they were played. If you have NAV, try disabling its autoscan setting for all the Video Directories & perhaps the SageTV dir too.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
01-18-2005, 08:20 AM
|
|||
|
|||
|
I had exactly the same problem with exactly the same drive upgrade. My problem was, the added drive had upped my power supply output to the point where it was interfering with the USB-UIRT.
I solved it by putting the USB-UIRT on a USB hub powered from wall current instead of the computer. Worked like a charm. Hope this helps.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
