|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#2
01-09-2005, 09:43 PM
|
||||
|
||||
|
You taught the codes to SageTV directly through the USB-UIRT, right? I think you would just exit SageTV and edit the properties file to remove the ui/rc_mappings/XXX lines.
Make sure to edit the properties file associated with the UI you are using -- if using the service mode, I believe you would need to edit sageclient.properties since the UI would be the one receiving the commands. - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
