|
Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
How do you slow down IR channel entry?
Hi -
I have SageTV running with Haupaugge's PVR-150 and IRBlaster, and my DirecTV Phillips receiver. Everything works well, except SageTV does not adhere to BlastCfg's input delays. Instead, it overrides them and enters the number faster than the receiver can respond. I have no problems with BeyondTV -- it properly adhere's to BlastCfg's settings. I also tried editing the Sage.properties->infrared_receive_repeat_delay, but it did not make a difference. All I need to do is slow down the rate at which channel numbers are entered. Any help would be appreciated! Thanks, Steve |
#2
|
||||
|
||||
I haven't used a 150's IR Blaster, so I'm not sure about this, but... in Source Details for the tuner using that blaster, can you select Tuner Control? If so, select the Remote Control Options button. You may then be able to change some of the delay settings. See pp. 118 - 121 in the v2.1 manual.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request. |
#3
|
|||
|
|||
Unfortunately, the Source Details do not offer me those settings.
Short of getting my hands on a new receiver, do you have any other ideas? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|