PVR-250 and PVR-150 together

[TJLeeland]

I've had a working SageTV setup going for a while with a WinTV-PVR-250. Today I bought a new PVR-150 to add to my system. When I booted up I installed the drivers for the 250, then, the second the drivers for the 150 were finished installing I got a BSOD. Now when I boot with both in the computer it blue-screens every time.

My question is: does anyone know if these cards have a problem working together? Anyone have a 250 and a 150 in the same computer?

Thanks,

TJ

[Sten3danny]

I also added a 150(MCE) to my perfectly working PVR-250 setup and had quite a few problems, no BSOD though.
I now have it working somehow, though not perfect, so it should be possible.
Have you tried putting only the 150 in, to make sure it's OK. Maybe try another PCI slot?

[SidKnee]

I've been trying to get a PVR150 working with a PVR350, with varying degrees of success, but at least no BSOD.

If the 150 is installed after the 350 and you go through the installation process Sage shows all the 350 inputs on the 150. Despite this I can get them both running using the Antenna inputs, but not the composite inputs.

I've raised this with support, and been through some testing with them but haven't managed to resolve it yet.

If I try the 150 on its own Sage crashes every time (although Win2k works fine).

Good Luck,
SidKnee

[TJLeeland]

Thanks guys. I took it back. I put the 150 in alone but couldn't get Sage 2.0 to see it, though XP seemed to like it. I figure I'll just get another 250 and keep it simple.