|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-21-2004, 07:11 PM
|
|||
|
|||
|
Upgrade V2 to V2.1: channels do not switch anymore!
I run into some issues with 100% CPU ussage.
I tried to fix it with upgrading to V2.1. Which it did. (http://forums.sage.tv/forums/showthr...9758#post69758) However, Sage doesn't switch channels on my PVR 350 card anymore! It doesn't seem to initialize the card anymore. All works fine with the Hauppauge TV viewer. If I don't use the Hauppauge viewer after a reboot I see just snow. After Hauppauge TV app usage Sage will stay at the last channel. I removed and added the source, did not fix it. 
|
|
#2
11-21-2004, 07:38 PM
|
||||
|
||||
|
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
