|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-20-2004, 02:27 PM
|
|||
|
|||
Switch from Drive Letter (C:) to UNC (\\as\c)?
I have the Sage Server setup to record to G: and H: which I real hard drives in the server, not mapped drives. I was wondering what would happen to previously recorded shows that are archived or sitting in recordings if I switched to using \\sagetv\g and \\sagetv\h for my paths.
I want to do this because I want to run the SageTV service, but can't have mapped drives when doing it. Make sense? TIA 
|
|
#2
11-20-2004, 02:41 PM
|
||||
|
||||
|
See This FAQ entry. But, be aware that if you are using the service, you have to log in as a user w/a password to use UNC paths. See the manual for more info on that.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
