|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-11-2004, 11:56 PM
|
|||
|
|||
Sage Installation Folders
Okay, another newbie question...
When I run the install for SageTV, it defaults to C:\Program Files\Frey Technologies\SageTV. This is also the default for the SageTV Client. When installing both the "server" and the client on the same PC for MVP installations, is it best to install these two applications into separate folders or can they co-exist? It would seem co-existing would make sense, especially since given the fact that there is a "Common" folder under SageTV. I know there has been much discussion about installing two clients in the same folder, or not, but I haven't seen mention of installing the client and server in the same folder. Thanks in advance... Brian 
|
|
#2
11-12-2004, 12:03 AM
|
||||
|
||||
|
I would install them in separate folders... if for no other reason than the fact that you could have competing properties files. SageTVClient uses SageClient.properties... but so does the SageTV UI when you use the service.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
