"Audio Delay" doesn't work in SageClient 2.1

[wazkaren]

This weekend is my first attempt at using Sage to display recordings from my Hauppauge card so I'm new at this. Previously I only used Sage to record and would use a MediaMVP to watch. I'm using SageClient on a low-end pc to watch recorded programs from a Hauppauge 250 on my main pc. Here's the low end PC:

700 Mhz AMD Duron
MSI K7T turbo motherboard
ATI 9600 SE
128 Mb Ram (another 256 mb is on order)
On board Sound
Sonic Decorders
Sony RP LCD 42" TV.

With Sage 2.0 I ran into an audio sync problem. Couldn't find the cause of the problem but found I could correct it with an "Audio Delay" of 200 ms. Everything was good. Then I upgraded both my Sage Server and Sage Client to 2.1. Now I've discovered that Sage Client is unaffected by the "Audio Delay" setting and I'm out of sync again. I even tried putting in a big audio delay to see if it would take effect but nothing changes no matter what the problem. I went back to Sage 2.0 and it works great again.

Does anyone else have this problem with Sage Client 2.1? Until I can get this to work (or fix the cause of the sync problem) I can't move up to 2.1.