|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
10-02-2004, 01:10 PM
|
||||
|
||||
|
SageTV, USB-UIRT, 2 6200 STBs... how do I control both independently?
well I just got my UIRT and am successfully using it for one cable box, but I would like to control the second as well, (I have a shield over the UIRT so it doen't send signals to the second box) I do have the UIRT that is configurable for three zones, I understand how to make the ir transmitter cable to plug into the back of the UIRT, but how would I control what signals go to each "zone"? would I do this in sagetv or some other route?
Thanks in advance 
|
|
#2
10-02-2004, 01:23 PM
|
||||
|
||||
|
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
10-02-2004, 01:29 PM
|
||||
|
||||
|
haven't read it all yet, but great reading! thanks!
sorry, I tried to search the forum and I was searching for 2 on things not 3 thanks again Opus4, you rock! BTW, finally figured out that s-video setup on my pvr250mce, thanks for your input on that as well
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
