|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
09-26-2004, 10:08 PM
|
|||
|
|||
|
Scrambled picture with SageTV...fine with WinTV2000
I've tried various combinations of settings but have been unsuccessful. When I use WinTV2000, both the sound and picture are fine. When I use SageTV, the sound is fine but the picture is completely "scrambled".
I have an ATI 9600se video card and a Hauppauge WinTV PVR 250. I'm not using a TV, only my computer monitor. I'd appreciate any suggestions you may have. Thanks 
|
|
#2
09-26-2004, 10:18 PM
|
||||
|
||||
|
Is this a new 250? Go to the SageTV Support page and look for the note about the 250 driver update towards the bottom.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
09-26-2004, 10:50 PM
|
|||
|
|||
|
Well, I feel a bit dumb now. The driver fixed the problem. I had looked everywhere, except of course the bottom of the support page. Many thanks!
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
