|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-31-2004, 09:14 AM
|
|||
|
|||
|
client hangs on startup
i've been running client successfully for a couple of weeks. This morning when launching it goes through the normal loading step and then hangs to loading interface mgr thread.
i did load the nilm skin yesterday and it was working fine last night... i've edited the properties file to revert back to originalv2, but the same behavior. anything i can do short of a reinstall? thx 
|
|
#2
08-31-2004, 09:29 AM
|
||||
|
||||
|
You could try renaming your properties file & its backup to see if starting fresh clears it. You'll have to reconfigure your client's settings, though.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
