|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
08-26-2004, 06:05 PM
|
|||
|
|||
|
Help, Sage starts recording immediately after launch
Every time I start Sage it immediately starts recording and showing whatever is on the channel it last used. It never used to do this. The show it is recording is not on the schedule or favorite lists. To stop the recording, I have to go through Watch Now then Close File to get Sage to stop recording.
Any ideas on how I can stop this and get Sage to just start without immediately showing and recording a show randomly? I have gone through all the on-screen options and have checked the properties file and didn't find anything that seemed to control this action. (fyi, I'm using Malore's STV) Thanks, Steve 
|
|
#2
08-26-2004, 06:12 PM
|
||||
|
||||
|
Do you have IR (Intelligent Recording) turned on?
Jere
|
|
#3
08-26-2004, 06:16 PM
|
||||
|
||||
|
Use the Options command on the main menu (Ctrl+o or right click) OR go to Setup -> Detailed Setup -> Multimedia tab -> Video Menu Options.
Is "Display Video on Menus" set to "Always"? Set it to "If Active" or "Never". - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#4
08-27-2004, 03:50 PM
|
|||
|
|||
|
Thanks for the information!
I did not have IR on but I did have Display Video on Menus set to Always. Not sure how I got it into this mode. Changing this to If Active or Never took care of the problem. Thanks again, Steve
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
