|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-26-2004, 08:06 AM
|
|||
|
|||
|
USB-UIRT - problem
I just ordered my SageTV and PVR-350 card and USB-UIRT and I have small dificulty to configure USB-UIRT to work. I am unable to change channels on my satelite or cable box. Is there anything I should know? where can I configure it? I was hoping I could enter some symbols of the receivers I have and they should be recognized. How does it work? Where could I get more information on how to get it working with my software and devices?
Thank you so much. Chris 
|
|
#2
06-26-2004, 11:06 AM
|
|||
|
|||
|
I was able to get my cable to work with explorer 8000 by grabbiing some ir config from this board, but I have dish 301 reciver for my satelite and this does give me the most problems. I cannot change channels on my DISH 301 receiver. What can I do? does USB-UIRT device work with dish 301 receiver?
Thank you. Chris
|
|
#4
06-26-2004, 05:09 PM
|
|||
|
|||
|
Thank you so much but somehow my usb-uirt is still not working with this setup.... It is strange, my cable box works just fine but my dish network 301 unit is not working....
Thank you. Chris PS: is there any other choice that I could try? I heard maybe there is some different way that UIRT is not supporting?
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
