|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-04-2004, 09:37 AM
|
|||
|
|||
|
HD channels, listing but w/o recording?
Is it possible to have HD channels listed with guide data and make intelligent recording never use them? It would be nice for Sage to move my big dish and tune the channels, then I could just switch the TV input; I just don't want Sage returning and attempting to record.
|
|
#2
06-04-2004, 10:16 AM
|
||||
|
||||
|
I don't know of any way to currently get intelligent recording to ignore a channel other than to remove the channel from your lineup.
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
