usb-uirt worked in v.6 not in v.7

[watts5ive]

I had everything working in version 6. Two 1600's for ota, 1 hd-pvr for dish, used hauppauge 45 button for sage through 1600, usb-uirt to change dish 222k. Upgraded to v.7, cannot get usb-uirt to change channels, used old remote profile from v.6 and tried new profile and still no usb-uirt. I cant get hauppauge to work through 1600's anymore either, have to use hd-pvr to get hauppauge to work. Ive disable tuners to try get hauppauge to default to a 1600 but will not work. Im ok using hd pvr for huappauge remote Ive just read were people say its better to not use hd-pvr for hauppauge remote. I even used usb-uirt to receive hauppauge remote which worked but still no usb-uirt to change dish 222k. Ive done newest drivers, hauppauge clear of all drivers and reinstall, any help would be appreciated Iv been reading these forums for hours. The lights on the usb-uirt flash when trying to change channels. Thanks in advance.

[PLUCKYHD]

I use it fine to change my 211k. Try my ir file and see if you have any luck remember you have rename it to .ir and put it in your commons folder

[watts5ive]

Thanks for the info and file. Ill try this here in a little bit. Is version 7 a full install or do you install over version 6.

[PLUCKYHD]

I believe you can install over I run whs Which I always uninstall first.

[watts5ive]

I fixed it. I noticed in the remote settings the repeater/duration had been changed to 2. I changed to 6 and it works.