|
Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
|
Thread Tools | Search this Thread | Display Modes |
#1
|
|||
|
|||
signal strength
I'm having one channel (OTA) that is giving me a lower signal strength on my HDHR.
It bounces from 75-95 and at times will hiccup my recording. My other tuners are at 100% and reading here most say that the HDHR has the best sensitivity, which gives me some concern. This is at channel 4-1 (CBS in Buffalo NY) digital ch.38 My tuners: This is on ch. 4-1 only Haup. -1600 = 100% Haup. -950q = 100% HDHR = 75-95% both tuners Haup. 1800 = same as above, but always gave me trouble. Came with the Quad computer. Had 4 output amp on it. same Had 4 splitter on it. same Swap cables many times. same Could I have a problem with the HDHR or am I being a little picky? |
#2
|
|||
|
|||
Sounds a little like a multi-path problem. That is where the signal bounces off a nearby hill or tree and gets to the antenna a fraction of a second later then the original signal. This will confuse the tuner. You will see the bars fluctuate a lot and then occasionally to zero. Picture usually seems jerky.
Is the CBS station in a different direction than most of the other stations? Sometime just moving the antenna a little will fix it, especially if you have a directional antenna. The HDHR is about as good at dealing with this as any tuner I have used. Different Antennas do better at filtering out multi-path than others. |
#3
|
|||
|
|||
Quote:
My two HDHomeRun's refuse to tune ch.18 (except when I hold a hand held flat panel antenna 90 degrees to the station). I have been atempting to resolve this issue for four months. It is begining to look like the HDHomeRun tuners actually tries to receive two channels at the same time, (due to poor signal rejection), causing the signal level to vary wildly as the tuner atempts to lock. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
On-screen signal strength? | Dingdul | SageTV Software | 10 | 08-07-2009 09:26 PM |
Signal Strength Monitor | benjamintm | The SageTV Community | 3 | 11-26-2008 11:58 AM |
Signal Strength | eded9698 | SageTV Beta Test Software | 5 | 12-06-2006 06:03 PM |
HDTV Signal Strength? | chrisc16 | Hardware Support | 13 | 12-13-2005 01:32 PM |
Signal strength...? | David81 | Hardware Support | 3 | 08-24-2005 08:29 AM |