HD200 & Webserver - How Do I Connect To It On My LAN?

[Savage1701]

I can connect to my Sage server with N's Webserver utility just fine; I'm not sure how to access my HD200, which I thought I read you could control with that utility.

How would I do that over my LAN? I don't need to go through a firewall or open a port or anything like that, just want to get at it from a laptop on the same LAN network in another room. For instance, http://192.168.1.35:8080/sage/about.html gets me to my Sage server in that case.

Thanks for any help. I hope I have the right forum, as I'm not sure if this belongs in the extender forum or the customization forum.

[Djc208]

Haven't tried it with the HD-200 but the control setup only works for extenders that are on and connected to the Sage Server. You won't see them if the're off (or with the HD-200/clients) not runnign the Sage interface.

[Savage1701]

Well, I think I am ok there - the HD200 is always on, and it is run as a client of the Sage server using the STV interface. I don't run it as stand-alone or anything like that.

[wayner]

When you bring up the webserver page when an extender is powered on it should show something like this:

Currently Watching:
On Sage Extender at: 001d6b4bfb48:  [WebRemote] [Power Off] [Reboot] 
Kids' Shows/Wiggles/Yummy Yummy 
Yummy Yummy  0.42GB Sun, Dec 30
3:04 PM  - 3:39 PM

When you click on the [WebRemote] then it brings up another screen where you can acess all of the commands to control the extender via your browser.

[Savage1701]

Thank you - for some reason I was going to the "about" page rather then the "Home" page, where it is right there in front of me.

Thanks for your time. That's exactly what I am looking for.