|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
04-01-2004, 09:40 PM
|
|||
|
|||
|
Sage stops at the end of a recording
Scenario
I am watching a half hour program. I decide to pause it at the 15min mark. I start playing again at the 20 min mark. At the 30 min mark I am 25 minutes into the program and it stops playing. How do I make it so that it will continue playing instead of stopping? 
|
|
#2
04-01-2004, 09:44 PM
|
||||
|
||||
|
I remember reading someone else's comment along those lines a while back... not sure if it was resolved. What happens when playback of that program stops? Does the channel change at the end of that show to start a scheduled recording? Does it stay on the same channel & playback simply jumps to the start of the next show?
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
