|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
03-13-2004, 07:16 PM
|
|||
|
|||
|
no capture card after update of PVR350
I have a pentium III, 800mhz, w/ pvr-350 installed. I downloaded and installed the SageTV trial software. It worked fine except for OSD and I had 350 out enabled. I decided to update Hauppage software with new release as of Feb 2004. After installing updates, PVR350 software works, however, SageTV wizard setup will not see the PVR350 device. I've tried to remove and reinstall the SageTV software, but it still will not work.
Please help.
__________________
keabler 
|
|
#2
03-13-2004, 08:25 PM
|
||||
|
||||
|
Be sure to check your sage.properties file for "ignore_networkencoders" Delete the entry for the pvr-350 if you find it. If SageTV starts several times and can't find your card (or you are in the middle of the Hauppauge driver upgrade ordeal) it will add it to this list.
Deadbolt
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
