|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
11-28-2008, 12:05 PM
|
|||
|
|||
|
Overlay/VMR/Default...
When I watch an HD show with the "Default" video renderer, my HD shows are full screen with no over/under scan, but when I bring up menus, they are slow and sometime then don't always "go away" when I hit exit (part of the menu stays on screen even though its "closed"). When I use Overlay, everything works fine except I get a tad bit of undersan on the bottom of my screen. I get a 2cm black horizontal bar (its barely noticeable). When I try VMR9, I get audio, but no video. All of this is using the ATI MPEG Decoder as my Video Decoder option. I have the latest ATI Catalyst Control Center installed.
I dont quite understand the difference between overlay and VMR9. Would I actually get any benefit from using VMR9 vs. Overlay? Thanks 
|
|
#3
11-30-2008, 06:52 AM
|
|||
|
|||
|
__________________
SageTV 6.6.2 / 42" Plasma Panasonic TH-42PX600A/ Intel Pentium DC E6500/ 2Gb Ram/KWorld DVB-T PC160-2T/ Logitech Harmony Remote X360/ Gigabyte GeForce 8500 GT (Silent)/ Winfast DTV1000T/ WD Caviar Green 808Gb HD/ Win 7 Ultimate/ Mission Cinema 7/ Denon AVR-1800
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
