QAM Channels Not Showing

[mwhittaker1024]

I have a HDHR that I use to get QAM channels. After upgrading to 6.4.8 and following the new instructions for the HDHR, none of the QAM channels are tuning.

When I try to access them thru "Setup->Setup Video Sources" they come up after a few seconds. This happens for any QAM channel I pick. However, when I try to access those channels using the Program Guide, I get a "No Signal" message.

Thanks

[mwhittaker1024]

Almost forgot...

I did a clean install of 6.4.8 and used the wiz.bin from the previous install.

[Conejo]

This has been happening for people who don't enter their cable lineup channel # when doing the SiliconDust HDHR Channel Setup.

There have been a number of changes to the previous setup. Please make sure you read every word of the new instructions with the original SageTV3.XML STV.

Tuner Configuration Tips & Instructions
>>> HDHR/digital tuning in v6.4

[mwhittaker1024]

Originally Posted by Conejo

This has been happening for people who don't enter their cable lineup channel # when doing the SiliconDust HDHR Channel Setup.

There have been a number of changes to the previous setup. Please make sure you read every word of the new instructions with the original SageTV3.XML STV.

Tuner Configuration Tips & Instructions
>>> HDHR/digital tuning in v6.4

That was it. There was one channel that was selected that didn't have a corresponding channel lineup #.

Thanks