|
|
|||||||
| Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
06-12-2008, 01:47 PM
|
||||
|
||||
|
Actisys IR200L & Dish Vip211 Not Changing Channels
I'm using Sage 6.3.5.159 and I just switched from DirecTV to Dish and got a new Dish Vip211 receiver. I removed the DirecTV source in Sage and then added a new DishSatelliteReciever1 source and everything seems to have went correctly in the setup.
However, I can't get Sage to change the channel on the new receiver via the IR200L. I tried adding a new source device and have Sage learn from the Vip211 remote, but that didn't work either. It won't change it from the EPG or the remote. I searched the forums and found out the remote address in the receiver needed to be 1 for the DishSatelliteReciever1 source. I checked it, and it is. At this point, I'm stuck and don't know what else to try.  Any help would be appreciated. Thanks in advanced, -mark 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Selecting local OTA digital channels and Dish R5000 | brzez | SageTV Software | 2 | 01-21-2009 07:16 PM |
| Changing channels with R5000 | vorius | Hardware Support | 11 | 01-21-2008 10:05 PM |
| Program guide not changing channels | sdkeller | Hardware Support | 3 | 10-12-2007 10:26 AM |
| Sagetv changing set top channels | richardhood36 | SageTV Software | 3 | 03-18-2007 02:26 PM |
| Sagetv confused about changing channels through tuner or cable box | vmadahar | Hardware Support | 7 | 07-10-2006 12:14 AM |
Linear Mode
