|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
12-29-2003, 09:42 AM
|
|||
|
|||
Hauppauge Remote Power Button
Ok,
What's up with the power button on the remote not starting up SageTV? I mean, it sleeps it fine, but no bringing it back from sleep. What's up with that, and how do i fix it. I tried mapping the IR command in the setup, but it didn't work. What do I do to get the power button to open sageTV??? Z 
|
|
#2
12-29-2003, 10:09 AM
|
|||
|
|||
|
Refer to the Sleep with PVR 250 Remote? thread. Probably best to start at the end and work forward till you see what you want.
Ps: There is a minor issue with this fix if you tend to switch between the keyboard and remote a lot like I do. I have not posted because I think this is a rare occurance.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
