|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
02-06-2007, 12:15 AM
|
|||
|
|||
|
Issues migrating to "Service" Mode
I have been successfully using Sage 6 for several weeks "stand-alone" without the "service" enabled. Now I am trying to enable the service. After I enable the service and then launch the UI, my favorites are gone, my recordings are gone, etc. If I stop the UI and the service and then re-run the UI stand-alone, everything is back to normal. How can run in "Service" Mode and not lose all my information in the UI? Any help is appreciated.
- Ron 
|
|
#2
02-06-2007, 12:26 AM
|
||||
|
||||
|
Is the SageTVService.exe process actually running on your system? If it is, do you have a firewall set strict enough that sagetv.exe can't talk to SageTVService.exe?
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
02-06-2007, 12:38 AM
|
|||
|
|||
|
It appears my problem was that my SageTvService was using a different login than my client. When I made the service login with my standard login and copied Sage.properties to SageClient.properties, all seemed to work well. Does that make sense? Thanks for your assistance.
- Ron
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
