SageTV Community  

Go Back   SageTV Community > Hardware Support > Hardware Support
Forum Rules FAQs Community Downloads Today's Posts Search

Notices

Hardware Support Discussions related to using various hardware setups with SageTV products. Anything relating to capture cards, remotes, infrared receivers/transmitters, system compatibility or other hardware related problems or suggestions should be posted here.

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 01-29-2007, 09:26 PM
pdavis pdavis is offline
Sage User
 
Join Date: Dec 2004
Posts: 18
I have the USB-UART connected and the driver installed. I have a 45 key Hauppauge remote that I would like to use with it and SageTV 6 client. I went into the Detail setup and told Sage to use the USB-UART. I then went to map the IR commands but nothing seems to happen when I hit a button on the remote (other than the LED lighting up on the USB-UART). Sage does not respond to the remote at all.
Reply With Quote
  #2  
Old 01-29-2007, 09:37 PM
Opus4's Avatar
Opus4 Opus4 is offline
Administrator
 
Join Date: Sep 2003
Location: NJ
Posts: 19,624
Was the USB-UIRT recently installed? If so, did you restart SageTV after installing it?

Confirm that in Detailed Setup -> Commands, the Remote Control Config says "USB-UIRT receiver".

- Andy
__________________
SageTV Open Source v9 is available.
- Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1.
- Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus
- HD Extenders: A) FAQs B) URC MX-700 remote setup
Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
Reply With Quote
  #3  
Old 01-31-2007, 09:46 PM
Skybolt's Avatar
Skybolt Skybolt is offline
Sage Icon
 
Join Date: Aug 2006
Location: Annapolis, MD
Posts: 1,027
Did This get resolved?

I am in the same boat, USB-UIRT works fine with HomeSeer and MainLobby for some time now. Setup, is set to use UIRT as Andy states, Restarted service and no-go. I am trying to learn an STB Remote for external control by SageTv.

Usally the UIRT has a popup window when learning the remote, this never pops-up. I also tried the IR_Helper app while Sage was in the learn mode and the IR app displayed the signal but Sage did not respond. I am using the latest build of sage and the latest driver v1.4 of the UIRT.

Thanks,
SkyBolt
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 08:30 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2023, vBulletin Solutions Inc.
Copyright 2003-2005 SageTV, LLC. All rights reserved.