|
|
|||||||
| SageTV Software Discussion related to the SageTV application produced by SageTV. Questions, issues, problems, suggestions, etc. relating to the SageTV software application should be posted here. (Check the descriptions of the other forums; all hardware related questions go in the Hardware Support forum, etc. And, post in the customizations forum instead if any customizations are active.) |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
01-23-2007, 08:43 AM
|
|||
|
|||
|
Can not view all channels
Greetings,
I have basic cable from Comcast and I am using the Nvidia dualtv tuner in my sagetv box. I have very nice picture up till channel 65 after that I can not view any channels. Any ideas? 
|
|
#2
01-23-2007, 09:21 AM
|
||||
|
||||
|
Just to make sure: if you connect your cable directly to your TV (w/o any converter box), can you view those higher channel numbers on the TV?
- Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#3
01-23-2007, 09:59 AM
|
|||
|
|||
|
Well on my tv upstairs I can. And since they are fed through the same cable box switch I figured it would. I'm also not 100% sure but i swear I saw those channels when I initially set things up...
thanks for the reply opus.
|
|
#4
01-24-2007, 12:41 PM
|
|||
|
|||
|
Any ideas anyone? I want to record the NHL all-atar game tonight and versus is on of the channels not able to be viewed.
 I appreciate it.
|
|
#5
01-24-2007, 01:23 PM
|
||||
|
||||
|
I'm not sure what would cause it, but until someone else has a better idea, if you are using a straight coax connection ot the tuner w/o a converter box, then you could try searching the forum for FreqShifter to see if that might help.
The tuner is set to Cable instead of Antenna in Source Details? - Andy
__________________
SageTV Open Source v9 is available. - Read the SageTV FAQ. Older PDF User's Guides mostly still apply: SageTV V7.0 & SageTV Studio v7.1. - Hauppauge remote help: 1) Basics/Extending it 2) Replace it 3) Use it w/o needing focus - HD Extenders: A) FAQs B) URC MX-700 remote setup Note: This is a users' forum; see the Rules. For official tech support fill out a Support Request.
|
|
#6
01-24-2007, 02:31 PM
|
|||
|
|||
|
I sure hope so
 I'll have to check when I get home. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
