USB-UIRT sends one too many digits

[raptor]

Everything went smoothly with the install between USB-UIRT and Sage, however, everytime I hit a channel number (2, 3, 4) in the guide, I get the number/digit being sent twice. Here are some of my trial/error setting in the .ir and the results below:

0,0, 300, 800 RepeatCount 1, did 22, 33,44
300/800 RepeatCount 2, did 22..2, 33..3
300/800 RepeatCount 0, did 22..2, 33..3
50/800 RepeatCount 1, did 22, 33,44
50/50 RepeatCount 1, did 22,33,44
500/1 RepeatCount 1, did 22,33.44

It does 22 instead of 2 etc..etc..
My STB is a Entone IPTV Box from Consolidated Communications.
Using USB-UIRT version 1.4 driver

[Buster Groove]

Raptor, I may be way off base with this, but I once had a kind of similar problem. Check your system for two applications controlling the USB-UIRT at the same time, both sending out instructions to it -- perhaps Sage and Girder?

[raptor]

No Girder installed.
The setup was working great with my two DirecTV cable boxes, problems developed when I moved to the Entone.

[briands]

you might try re-learning the IR codes using "how to test and relearn IR codes". I had problems getting my codes in using the initial setup.

[raptor]

Ran through the re-learning multiple times--still problems. It's like this Entone box is extremely sensitive -- I'm going to return this IPTV box to the phone company and switch back to satellite or cable. If it doesn't work with my Sage - it's not ready for primetime

[SHS]

Try tapping the buttom in staed of hold the button that might work when re-learning the IR codes